MECHANICAL PROBLEMS
 

FITTING OF CARBON BRUSHES

When carbon brushes are replaced on a machine, they should be allowed to run under no load for approximately 20 minutes prior to use. This allows it to settle in. It should be noted that, the running times will be reduced, should the following guide lines not be followed:

 

- 1st set of brushes+/- 300 Hours

- 2nd set of brushes+/- 150 hours

- 3rd set of brushes+/- 75 hours

- 4th set of brushes+/- 30 hours

- 5th set of brushes+/- 13 hours

 

These guidelines are further influenced if the tool is used in an enviroment where it is exposed to abrasive dust. This would shorten the life of brushes.

 

N.B. Especially on 230mm Angle grinders when chasing.

 

 

Service Intervals For Power Tools:

All power tools should be serviced on a regular basis. Intervals will be determined by the average daily use of the machine.

Repairs

SERVICE INTERVALS FOR POWER TOOLS:

All power tools should be serviced on a regular basis. Intervals will be determined by the average daily use of the machine.

 

All machines supplied with six month warranty subject to our standard  terms and conditions, available on request.

No warranty claims on any wear and tear parts.

  
Any tampering with the power cord including the plug, will void the warranty.

All repairs not collected within thirty days will be sold to defray expenses.

© 2018 by ELECTROBRUSH​ Proudly created BY WAZZAP TECHNOLOGY

  • Google Square
  • Twitter Square
  • facebook-square